Electrochemical Research Corporation
Before you begin ArthriFon® treatments:
The spinal cord is most important and sensitive part in our body. Our overall health depends on the condition of the spinal cord.
All pain and control signals, which control body functions, comes to and from brain via spinal cords neurons.
The better physical condition of spinal cord the better we feel and better control your brain has over the body.
During sleep our brain is trying to correct all the damage done to the body organs during the day. When spinal cord neurons will have good electrical conductivities, the brain has better control over body functions. You will feel better, when you wake up in the morning after this appilication.
The spinal cord marrow is responsible for production of an adult stem sell. Amount of those cells decrease with age. Thus it is very important to increase their concentration now. Microvibrations and increasing blood circulation boosts population of a stem cells several times over after three to four hours after application. For this reason we recommend this intoroductory application before any other sessions with ArthriFon®.
During the application ArthriFon® increases amounts of blood and stem cells coming to the joints, which dramatically accelerates joint healing process.
This procedure will accelerate healing process, not only for particular joints, but over all over the body. The rest of ArthriFon® applications can be done after three to four hours after this application, when population of adult stem cell reaches its maximum.
According to French investigators and our research we found out that certain sound frequencies (around 1000 Hz) increase conductivity of spinal cord neurons.
See reference (please scroll to Fig 3, to find more information)
"From Subthreshold to Firing-Rate Resonance
Author: Magnus J. E. Richardson, Nicolas Brunel, and Vincent Hakim
Laboratoire de Physique Statistique, Ecole Normale Supérieure, 75231 Paris Cedex 05, France; Laboratory of Computational Neuroscience, Brain and Mind Institute, Ecole Polytechnique Fédérale de Lausanne, CH 1015 Lausanne, Switzerland; and Centre National de la Recherche Scientifique, Neurophysique et Physiologie du Système Moteur, Université René Descartes, 75270 Paris Cedex 06, France
Publication: J Neurophysiol 89: 2538-2554, 2003. First published December 27, 2002; .
For this procedure you have to use ArthriFon® switch "Mode" in position "1"(left) and Power switchin position "H"
*****The placement of the vibraphones shown on picture *****
To start using your ArthriFon®:
1. Unpack the device and remove the vibraphones from the holding case.
2. Connect the power supply to the ArthriFon® device and plug into an electrical outlet.
3.Install "Mode" switch in position "1" and 'Power' switch in position 'H'. This is very important.
4. Lie down on your back. You may place a small pillow under your back. You may need to use a semi-firm or firm mattress.
5. Apply vibraphones as shown on picture - 1/2 inches from center of spinal cord.
6. After you applied the vibraphones, push the "Start/Stop" button. It will stop automatically when the application is completed, after approximately 15 minutes.
7. You may move vibraphones for one inch down and repeat application for additional 15 minutes for better results.
8. The treatment is in progress while the red light is blinking and sound is heard. You can place pillow over vibraphones to muffle the sound.
9. If you wish to interrupt the treatment for any reason, you can push and hold for two seconds the "Start/Stop" button again, to stop the device.
NOTE:
Vibraphones must be held firmly against the body, but not be pressed too tightly to allow vibration to be felt .